Dachflächen-Rechner

So verwenden Sie diesen Rechner

1. 1Measure the length and width of your building footprint in feet — these are the flat, plan-view dimensions as seen from above.
2. 2Enter the roof pitch as rise per 12 inches of run (e.g., 6 for a 6/12 pitch). If you do not know your pitch, use the Roof Pitch Calculator first.
3. 3Select your roof type: Gable (two sloping sides), Hip (all four sides slope), or Shed (single slope).
4. 4Click Calculate to get the actual roof surface area, roofing squares, and pitch multiplier.

Über dieses Material

Roof area calculation is the foundation of every roofing material estimate. The most common mistake homeowners and even some contractors make is using the flat footprint area instead of the actual sloped surface area — this leads to significant material shortages, especially on steep roofs. The pitch multiplier converts flat area to true surface area using the Pythagorean theorem: multiplier = sqrt(1 + (pitch/12)²). For a standard 6/12 pitch, the multiplier is 1.118, meaning the actual roof area is about 12% larger than the footprint. At 12/12, the roof has 41% more surface area than the flat plan. Roofing materials are sold in 'squares,' where one square covers 100 square feet of roof surface. Asphalt shingles typically come in bundles of 3 per square, so a 2,400 sq ft roof needs 24 squares or 72 bundles. When ordering materials, always add 10-15% for waste from cuts, starter courses, ridge caps, and valleys. For hip roofs, add an additional 5% because hip ridges and valleys create more cut waste than a simple gable. Understanding your true roof area also helps you accurately estimate underlayment rolls, drip edge linear footage, and ice-and-water shield for eaves and valleys.

Einbautipps

• •Always measure roof dimensions from the eave to the ridge on the slope, not just the horizontal footprint — or use the pitch multiplier to convert.
• •For complex roofs with multiple pitches, calculate each section separately and sum the areas for the total.
• •When ordering shingles, round up to the nearest full square and add 10-15% for cuts and waste at hips, valleys, and edges.
• •Verify your pitch measurement on each roof plane — additions and dormers frequently have different pitches than the main roof.
• •For hip roofs, measure each triangular and trapezoidal section individually for the most accurate area estimate.

Häufige Fehler, die Sie vermeiden sollten

• ⚠Using the flat footprint area instead of the actual sloped roof area — this underestimates materials, especially on steep pitches.
• ⚠Forgetting to account for both sides of a gable roof — the footprint only shows one plane, but gable roofs have two sloped surfaces.
• ⚠Not adding waste factor — valleys, hips, and edges create cut waste that increases material needs by 10-15%.
• ⚠Confusing roofing squares with square feet — one square is 100 sq ft, so a 3,000 sq ft roof needs 30 squares, not 3,000.
• ⚠Ignoring dormers, chimneys, and other roof penetrations when calculating area — these add complexity and waste but reduce covered area slightly.

Verwandte Rechner