Dachgefälle-Rechner

So verwenden Sie diesen Rechner

1. 1Measure the vertical rise in inches — this is how many inches the roof goes up over the measured horizontal distance.
2. 2Measure the horizontal run in feet — this is the flat, level distance you measured across (not along the slope).
3. 3Click Calculate to get the pitch ratio (per 12 inches of run), angle in degrees, slope percentage, and material recommendation.
4. 4Use the material recommendation to confirm your roofing material is appropriate for your roof's slope.

Über dieses Material

Roof slope measurement is a critical first step before selecting roofing materials, because every roofing product has a minimum slope requirement set by the manufacturer and enforced by building codes. The slope is the ratio of vertical rise to horizontal run, and it directly determines how quickly water and snow shed from the roof surface. Flat and very low-slope roofs (below 2:12) require continuous membrane systems such as TPO (thermoplastic polyolefin), EPDM (ethylene propylene diene monomer), PVC, or built-up roofing (BUR) with multiple layers of bitumen and reinforcing fabric. These membrane systems create a watertight seal that does not rely on gravity to shed water. Low-slope roofs between 2:12 and 4:12 can use asphalt shingles, but only with special installation methods including double underlayment, additional sealant at every tab, and ice-and-water shield on the entire deck in cold climates. Standard asphalt shingles (3-tab and architectural) perform best on roofs with 4:12 to 8:12 pitch, where gravity effectively channels water off the surface. Steep-slope roofs above 8:12 benefit from heavyweight materials like concrete tile, clay tile, slate, or standing-seam metal panels that resist wind uplift and are mechanically fastened to handle the steep angle. Measuring your slope accurately — using a level, tape measure, and the rise-over-run method — ensures you select the right material and installation method for long-term performance.

Einbautipps

• •Use a 2-foot or 4-foot level and a tape measure for the most accurate slope measurement — longer levels reduce error from surface irregularities.
• •Measure from inside the attic along a rafter if the roof surface is inaccessible — place the level horizontal and measure the vertical drop at a known horizontal distance.
• •A smartphone inclinometer app can give a quick angle reading, but verify with a manual measurement for material ordering decisions.
• •Check slope at multiple locations — the main roof, garage, dormers, and additions often have different slopes.
• •Record the rise in inches and the run in feet (or inches) clearly to avoid unit conversion errors when communicating with suppliers.

Häufige Fehler, die Sie vermeiden sollten

• ⚠Measuring along the slope instead of horizontally for the run — run must always be the horizontal, level distance.
• ⚠Confusing slope percentage with pitch ratio — a 50% slope equals a 6:12 pitch, not a 6% slope.
• ⚠Assuming one measurement applies to the entire roof — multi-section roofs commonly have two or more different slopes.
• ⚠Using shingles on a roof below the minimum 2:12 slope — this violates building code and will likely cause leaks.
• ⚠Measuring rise and run in different units (e.g., rise in centimeters and run in feet) and not converting before calculating.

Verwandte Rechner